|
Monitor temperature, humidity, fuel levels, power supplies, security devices, and other variables that describe your network environment.
Environment monitoring probes developed by the InterMapper User Community include:
Netbotz 320 Probe [.zip]
Monitors the temperature, humidity, and airflow of a Netbotz 320 device. It will also alert when the camera motion sensor goes off.
APC Environmental Monitoring System Probe [.zip]
Monitors temperature and humidity for the APC AP9230 Environmental Monitoring System and alarms when thresholds are exceeded.
WeatherGoose Environmental Probe [.zip]
Monitors the very clever Weather Goose environmental monitoring device. The WxGoos-1 has built-in sensors for temperature, humidity, airflow, sound, light, and three I/O terminals and has a web, SNMP, XML, PDA, and WAP interfaces. This probe is for the WxGoos-1 internal sensors only. This probe graphs all the sensors and has low- and high-alarm and warning for temp. The WeatherGoose is made by I.T. Watchdogs, Inc.
EDS Environmental Monitor [.zip]
Monitors a few or a hundred HA7Net temperature sensors: see the HA7Net page for more details.
Ravica BitSight [.zip]
Monitors temperature, humidity, air flow and contact closures reported by te Ravica BitSight environmental monitor.
APC Environmental Monitor [.zip]
Monitors the temperature and relative humidity of an APC Environmental Monitor. This probe can monitor the values of up to two APC probes.
Environmental Monitoring Probe for MGE UM-Sensor [.zip]
Monitors an MGE "UM-Sensor" environmental sensor with a UM-Link Ethernet interface via SNMP. The probe can be used as a starting point for the design of similar probes, but this implementation assumes a single UM-Sensor (up to 4 could be daisy-chained) on the assigned comm port of the UM-Link interface (i.e. it only looks at the first entry in table that indexes sensor units).
Environmental Monitoring Probe [.zip]
Monitors the conditions (temperature and relative humidity) from an APC environmental monitoring card.
SNMP-Link Temperature Probe [.zip]
Monitors the temperature measured by the SNMP-Link SL60 & SL61 sensor units, manufactured by Omnitronix of Seattle, WA. These boxes also have RS-232 ports, switch closure inputs and relay outputs, all of which can be read by SNMP.
|
