Wireless Monitoring Probes

Monitor a wide range of wireless devices to receive alerts on signal strength, bytes in/out, antenna type, connected SSID, TX/RX rate and much more.

Wireless monitoring probes developed by the InterMapper Community include:

Tranzeo CPQ Probe [.zip] [ view ]
Reports Antenna Type, Firmware, Connected AP MAC Address, Signal Strength, Noise, Connected SSID, and Total Bytes In/Out. It issues all warnings from the SNMP Traffic probe and alerts on Low Signal, High Signal, and Low Transfer rate.

Ubiquiti CPE Probe [.zip] [ view ]
Reports Antenna Type, Firmware, Device MAC Addresses, Connected AP MAC Address, Signal Strength, TX/RX Rate, Connected SSID, Total Bytes In/Out. It issues warnings for Low Signal, High Signal, and Low Transfer rate.

Redline AN-80 Probe [.zip]
Probes a Redline AN-80 point-to-point radio, acting as either a master or slave, to retrieve and display a number of critical statistics for the radio, and give alarms based on user-specified thresholds.

DragonWave AirPair Probe [.zip]
Monitors Serial Number, AP Type, Modem Sync LED, Rx Cable Loss, Tx Cable Loss, RSL, and BER. Tim also provides the MIB for the radio along with the probe.

Breezecom Wireless Devices [.zip]
Monitors Breezecom line of equipment from Alvarion.

Bridgewave AR80Probe [.zip]
Monitors several variables of a Bridgewave AR80 radio: serial number, model number, received signal level (in dBm).

DragonWave Horizon Probe [.zip]
Monitors a DragonWave Horizon radio to report on: serial number, type and speed of DragonWave link, received signal level (in dBm), signal to noise ratio (in dBm), up/down status of link.

DragonWave Horizon Duo Probe [.zip]
Monitors a DragonWave Horizon Duo radio to report on: serial number, type and speed of DragonWave link, received signal level (in dBm) for both channels, signal to noise ratio (in dBm), up/down status of link on both channels.

LigoWave PTP Probe [.zip]
Monitors a Ligowave radio to report: current Tx frequency, signal level (in dB), link quality, configured speed (in kbps), transmit power (in db), channel bandwidth (in MHz), noise level (in dBm), MAC address of the unit.

Valere Rectifier Probe [.zip]
Monitors a Valere Rectifier to report: software version, overall module status, output voltage from slot 1 (divide number to get volts), output of rectifier in slot 1, internal temperature, AC failure, battery discharge.